Why is aquastop needed in a washing machine?

Washing machines are constantly being improved, and manufacturers are constantly adding new functions, which is why the cost of SM is growing. Many users believe that most of these innovations, for example, the aquastop function in a washing machine, are practically useless and only serve as an excuse for another price increase. Let's figure out whether this is really the case, or whether aquastop does have certain advantages.

Purpose of Aquastop

The simple and easy to remember word "Aquastop" is used to refer to a complex leak protection system built into the body of the washing machine (on the tray and on the inlet hose). If any element inside the washing machine starts to leak (say, a tank, a pipe, a pump, a powder receptacle, etc.), the sensor in the tray will immediately give the command to shut off the water. The sensor in the inlet hose is triggered if the rupture has already occurred inside the hose itself, and the water is also instantly shut off.

In fact, you shouldn't underestimate the importance and usefulness of the Aquastop function. After all, there are often situations when people flood their neighbors, and then they not only had to re-lay the floor in their apartment, but also do a major overhaul for complete strangers. Still, the option to pay a little more for a machine with a leak protection system and calmly leave the washing machine unattended, without worrying about a flood, looks more attractive.

What types of protective systems are there?

As mentioned above, most water protection mechanisms are located inside the tank, but this is still a generalization. Some protection systems are located outside the tank. Leak protection can be very different.

• Semi-automatic mechanism.
• Float with relay.
• Water Block System.
• Electromagnetic tap.
• A set of protective mechanisms with indication.

Read about each option separately and decide what suits you best and whether you need aquastop at all. What protection you ultimately choose depends on many factors, including the features of the machine itself, the state of the local waterway, and your personal views.

Let's at least protect the hose

Of course, if the machine was not initially equipped with the Aquastop system, it is almost impossible to install the sensor into the tray yourself, but it is quite possible to secure the inlet hose with your own hands.

The algorithm of actions is as follows:

• Disconnect the unit from communications,
• Disconnect the inlet hose. You may need to replace the sealing rings on it and at the same time thoroughly wash the coarse filters,
• Install the sensor on the water supply tap, turning the device clockwise,
• Connect the inlet hose to the aquastop.

Before you start a full wash, test your work. Run a weak stream of water into the hose to immediately detect and eliminate any malfunctions.